Saws
| "EDW" Diamond Saw | |
|---|---|
| Recommended Host machine: | Excavator 3½ t - 12 t |
| Cutting Depth Models: |
|
| Cutting Wheel Type: | Diamond impregnated cutting points |
| Approximate Tip Speed: | 30 m/s |
| Drive Mechanism: | Direct drive via a radial piston motor |
| Offset Extension Available: | Yes |
| Hydraulic Flow Required(a): | 300 mm cutting depth is 50 - 70 lpm 400 mm cutting depth is 65 - 90 lpm 600 mm cutting depth is 85 - 110 lpm |
| Hydraulic Pressure Required: | 300 mm cut is 190 - 220 bar 400 mm cut is 165 - 227 bar 600 mm cut is 175 - 260 bar |
| Hydraulic Power Required: | 300 mm cut is 11 kw 400 mm cut is 18 kw 600 mm cut is 28 kw |
| Note(a): | Host machine requires a Case Drain line to run Saw Attachment |
| Storage Stand: | Supplied with Saw Attachment |
| Saw Model: | "EDW" Diamond Saw |
| "ERW" Rock Saw | |
|---|---|
| Recommended Host machine: | Excavator 5 t- 12 t |
| Cutting Depth Models: |
|
| Cutting Wheel Type: | Self-Sharpening tungsten cardbide tipped picks |
| Approximate Tip Speed: | 3 m/s |
| Drive Mechanism: | Hydraulic motor via a planetary reduction gearbox fitted with a duo-cone seal |
| Offset Extension Available: | Yes |
| Hydraulic Flow Required(a): | 450 mm cutting depth is 60 - 90 lpm 600 mm cutting depth is 80 - 130 lpm |
| Hydraulic Pressure Required: | 450 mm cut is 175 - 242 bar 600 mm cut is 207 - 275 bar |
| Hydraulic Power Required: | 450 mm cut is 27 kw 600 mm cut is 31 kw |
| Note(a): | Host machine requires a Case Drain line to run Saw Attachment |
| Storage Stand: | Supplied with Saw Attachment |
| Saw Model: | "ERW" Rock Saw |